| | |  | Garage Door Controls | Home » » » Mighty Mule FM137 Digital Keypad | | | | | | | Description: | | The Digital Keypad is designed to control access to all GTO/Mighty Mule automatic gate openers. It can be programmed to use up to 25 different personal identification number (PIN) codes, and each code can be set up as temporary or permanent security access codes. Each code is face programmable with additional security features built in. This Digital Keypad can be easily installed as a Wireless or Wired Keypad. Requires 3-AA batteries (not included). U.S.A. Application: Digital keypad, Works With: GTO/Mighty Mule automatic gate openers, Compatible With Item Number (s): 3467 | | | Features: | |
• This keypad provides convenience and security, and is compatible with all GTO/Mighty Mule automatic gate openers
• Easy to program new and remove old access codes, and can handle up to 25 unique access codes
• Restricts gate access to only residents and invited guests
• Ideal for residential and commercial use
• The FM100 Mounting Post is recommended for mounting the digital keypad
| | | Product Details: | | | Product Length:
| 5.0 inches | | Product Width:
| 3.0 inches | | Product Height:
| 9.5 inches | | Product Weight:
| 1.0 pounds | | Package Length:
| 9.1 inches | | Package Width:
| 5.3 inches | | Package Height:
| 2.3 inches | | Package Weight:
| 0.75 pounds | | Average Customer Rating:
|  based on 21 reviews |
| | | | Customer Reviews: | |
Average Customer Review:
 ( 21 customer reviews )
Write an online review and share your thoughts with other customers.
Most Helpful Customer Reviews
9 of 10 found the following review helpful:
 Better than expectedAug 24, 2008
By S. Dalal
It is nice that you have the option of using this in a wired or wireless configuration. In my case, wireless was the only way to go.
Like other 'programmable' wireless remotes, I expected a little pain in programming this one. The instructions have you press a certain key sequence and hold a working remote close to the unit until it beeps. The manual says it takes a little while. I must be impatient because I held it there for a good long time and it never beeped. But I tried it again and held the transmit button down for a very long time and sure enough, it finally beeped.
Programming access codes is very easy, much easier than other keypad devices I've used.
There is no delay in transmission, either. When I enter my code (I like the lighted button and beep feedback), my gate starts to open immediately.
Mounting is trivial.
6 of 7 found the following review helpful:
Works as advertisedAug 18, 2008
By Mark L. Weber
Works so good I bought one for the inside of my gate too. Had a problem programming the second one, it wouldn't learn the code the first day. Tried several times. Worked first thing the next day, must have been radio interference. Other than that, works GREAT!
5 of 6 found the following review helpful:
 Painful For Guests To UseFeb 01, 2010
By Kirk S.
"Sans Dieu Rien"
I constantly have to tell friends and relatives that they must press the buttons with, "Fortitude and purpose." It's a never-ending battle of guests not being able to enter. Eventually, they yank on the gate, causing the gate opener to be out of alignment.
I feel like I'm babysitting. I have to watch the tiny blinking light to figure out if the code was enter in correctly. HINT: If you see a doubling blink at the end of your entry, then it worked!
Works great :)May 03, 2012
By m.andb.ranch
The keypad works great so far. I do wish it had a cover to protect the buttons. Not sure how they are going to hold up in the sun. Other than that I'm very happy with it.
 I tried, I give upApr 30, 2012
By trevor
This is a great product when it works. But I have been through three of them. Each one quit working after a few days to a couple of weeks. Talked to customer service, they sent a new one each time, but after three faulty products I do not have the time or patience to keep trying until I get one that wont fail.
See all 21 customer reviews on Amazon.com
| | |
|
View Cart
